DSCF0634

PROJECT 8 – ANALOG DISTANCE SENSOR TO LCD DISPLAY

PROJECT 8

ANALOG DISTANCE SENSOR TO LCD DISPLAY

Back to Project 7                                                                                                          Go to Project 9

Analog distance sensor, which are mainly use to measure the distance of an object. The advantage of this sensor is the accuracy of sensor can measure the object distance up to centimeter(cm). In this project, we going to interface this sensor to Arduino Deuemilanove and display the value it Arduino LCD Keypad shield.

———————————————————————————————————————————————————-

COMPONENT NEEDED

———————————————————————————————————————————————————-

BREADBOARD
ANALOG DISTANCE SENSOR
ARDUINO LCD-KEYPAD SHIELD
JUMPER WIRE

———————————————————————————————————————————————————-

CONNECTION

———————————————————————————————————————————————————-
Analog distance sensor have 3 pins which is VDD, GND, Vout. Connect the Vout to analog pin-1GND to ground and VDD to 5V.

1-Vout      2-GND       3-VDD(+5V)

———————————————————————————————————————————————————-

ADDITIONAL INFORMATION

———————————————————————————————————————————————————-

Referring to the chart above are the output voltage(V) versus distances(cm) of the analog distance sensor. By plotting the output voltage versus inverse number distance (1/cm), we can get the linear relation such as in figure below.


The linear equation is y = 20.99x + 0.19, where y is voltage output and x invert distance. Notice that the trusted output voltage are about 0.4 to 2.8 V.

———————————————————————————————————————————————————-

CODE OVERVIEW

———————————————————————————————————————————————————-

Vout = (range*500000)/1024;
Get the ADC value and apply formula where to make the value in voltage with larger value.
E.g: adc_value = 1022,
~ if using adc_value*5/1024,
Vout = 4
~ if using adc_value* 500000/1024
Vout = 499023

if ((Vout > 43945) && (Vout < 279785))
Check the Vout value whether is between 43945 and 279785.

range = (Vout – 19000)/2099;
Determine the range by apply the formula given.
E.g-1 : if Vout = 279785
279785 – 19000 = 260785
1000 / 124 = 8

Set the LCD cursor and clear the value.

Back to Project 7                                                                                                          Go to Project 9

———————————————————————————————————————————————————-

ATTACHMENT

1. P8 User Manual.pdf
2. Project_8_code.zip

Buy

, , ,

Related Post

Jpeg

How to Make your Line Following Robot Faster?

Control Mobile Robot through WiFi with ESP-WiFi Shield (Arduino + Andriod)

Arduino + 2A motor + Encoder

Arduino + 2A Motor Shield + Encoder Motor

ESPresoo Lite V2 Package

Bringing IoT to Everyone – Collaboration of ASEAN Makers

One thought on “PROJECT 8 – ANALOG DISTANCE SENSOR TO LCD DISPLAY

Leave a Reply

Your email address will not be published. Required fields are marked *