Let’s Arduino Control Your SmartDriveDuo-60

Serial Packetized: ID is 0

1. Program your Arduino with the following codes. Then disconnect Arduino from the USB.

2. Set switch mode on MDDS60 to 0b11001100.
3. Connect all the wires as shown below and connect the battery

CT-UNO Serial Packetized

*9V battery is only to show how to make a connection between MDDS60 and battery. Use a suitable battery for your application.
**Please make sure there only one 5V supply to Arduino board.

4. Once MDDS60 and CT UNO is powered up (and all connections is complete), both motor will start moving alternately.

Continue on next page…

Leave a Reply

Your email address will not be published. Required fields are marked *