In this tutorial, you will going to learn on how to interface this product with SK40C and BBFUINO with Thermocouple K in order to measure the temperature. The sample source code was attached at the end of this tutorial.
In this tutorial, you will going to learn on how to use the RF-TX-315 and RF-RX-315 as remote controller to switch on and off the fluorescent lamps by using PT2262 and PT2272 ICs.
In this tutorial, you will learn on how to display the character on LCD by pressing the 4×4 keypad button.
The FlexiForce single element force sensor acts as a force sensing resistor in an electrical circuit. When the force sensor is unloaded, its resistance is very high. When a force is applied to the sensor, this resistance decreases. The resistance can be read by connecting a multimeter to the outer two pins, then applying a force to the sensing area. In this tutorial, you will going to learn on how to display the voltage level on 2×8 LCD and light up the LED based on the voltage level as the different force exerted to the Flexiforce Sensors(A201).
In this tutorial, you will going to learn on how to implement and use the flexible bend (for SN-FLX-01 and SN-FLX-02) by using BBFuino and SK28A. The setup and the source code shared at here will result the voltage display on LCD as you bend the flexible sensor.
In this tutorial, a project on creating the wireless communication in between SK28A and BBFuino was implemented by using two RF-TRX-2.4Gs.
The output signal of Digital Infrared Sensor is needed to be pull high as it is NPN output. The module will output a HIGH if no object is detected and a LOW if an object is detected. In this tutorial, you are going to learn on how to use the BBFuino and SK28A to control SN-E18-B03N1.
In this tutorial, you are going to learn how to compile the source codes (by using Cytron Technologies DIY Project ) with MPLAB v8.63 and Hi-Tech compiler v9.80.